5
WWW.EILERSEN.COM
Introduction
This document describes the use of a 5024G LCD display terminal from Eilersen Electric,
when the software version listed on the front page is installed.
With this software, the terminal can perform automatic dosing (coarse/fine) using its digital
outputs and inputs. One digital output is used for coarse dosing and one digital output is
used for fine dosing, while a digital input is used for start of dosing and a digital input is used
for registration of dosed amount.
Installation
The following steps must be performed before the system is used:
•
Install the load cells and check mechanical installation
•
Optional: Connect digital outputs and digital inputs
•
Connect and apply power
•
Check software version
•
Optional: Activation of Intelligent Setup feature
•
Set up load cell configuration
•
Power cycle the unit
•
Configure weighing ranges
•
Perform coarse taring
•
Optional: Configure display, filtering, zero tracking range, stability requirement
•
Optional: Corner calibration, system calibration, linearization
•
Perform load check
Please notice:
Perform a load check before the system is used to be sure that all require-
ments regarding accuracy, stability etc. are met before the system is used.
Please notice:
If the Intelligent Setup feature is used, this will perform some of the subse-
quent points in the above list.
Details on the steps needed to install the system are explained below.
How to
–
Perform basic operations
When the system is installed and power-up sequence has ended the display will look like this:
