nents of the appliance get wet, unplug the appliance im-
mediately. (Non-immersible equipment only)
2 )
If the appliance shows any sign of abnormal water leakage,
immediately unplug it from the power source. (Immersible
equipment only)
3 )
Carefully examine the appliance after installation. It should
not be plugged in if there is water on parts not intended to
be wet.
4 )
Do not operate any appliance if it has a damaged cord or
plug, or if it is malfunctioning or has been dropped or
damaged in any manner.
5 )
To avoid the possibility of the appliance plug or receptacle
getting wet, position aquarium stand and tank to one side
of a wall-mounted receptacle to prevent water from dripp-
ing onto the receptacle or plug.
A ”drip loop”, shown in the figure, should be arranged by
the user for each cord connecting an aquarium appliance
to a receptacle. The ”drip loop” is that part of the cord be-
low the level of the receptacle, or the connector if an ex-
tension cord is used, to prevent water traveling along
the cord and coming in contact with the receptacle.
If the plug or sock-
et does get wet,
DON’T
unplug the
cord. Disconnect the
fuse or circuit break-
er that supplies pow-
er to the appliance.
Then unplug and ex-
amine for presence
of water in the re-
ceptacle.
c )
Close supervision is ne-
cessary when any appliance is used by or near children.
d )
To avoid injury, do not contact moving parts or hot parts such
as heaters, reflectors, lamp bulbs, and the like.
e )
Always unplug an appliance from an outlet when not in use,
before putting on or taking off parts, and before cleaning.
Never yank cord to pull plug from outlet. Grasp the plug and
pull to disconnect.
f )
Do not use an appliance for other than intended use. The use
of attachments not recommended or sold by the appliance
manufacturer may cause an unsafe condition.
g )
Do not install or store the appliance where it will be exposed
to the weather or to temperatures below freezing.
h )
Make sure an appliance mounted on a tank is securely in stalled
before operating it.
i )
Read and observe all the important notices on the appliance.
j )
If an extension cord is necessary, a cord with a proper rating
should be used. A cord rated for less amperes or watts than
the appliance rating may overheat. Care should be taken to ar-
range the cord so that it will not be tripped over or pulled.
k )
This appliance has a polarized plug (one blade is wider than
the other). As a safety feature, this plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified elec-
AQUARIUM
TANK
APPLIANCE
POWER
SUPPLY
CORD
DRIP
LOOP
Содержание aquaCorner 60
Страница 2: ... A A 7428910 2616000 7445858 50 Hz 7445868 60 Hz 7428900 7325018 ...
Страница 3: ...A B B B C C ...
Страница 36: ...B C ...