EHEIM 2227, Руководство пользователя

Страница: 21 / 162

Examine the wet/dry floater compartment to make sure it is
securely attached to the filter canister: the upper connection
must be firmly inserted into the canister; the two lower
locking pins must be closed so that the slots are each in
a horizontal position (horizontal = closed, vertical = open).
Easy access to the locking pins is provided by the enclosed
locking key.
17
Slightly lubricate the o-ring of the output pipe and insert it
firmly into the pump cover. Examine the sealing gasket on the
pump head of the filter for cleanliness and proper fit.
With the output pipe inserted into the intake of the impeller
lid, place the pump head onto the filter canister, so that the
output pipe is guided through the openings of the media con-
tainers and fits correctly into the wet/dry connection at the
bottom of the canister. Close all four EZ clips.
ATTENTION: Before the integrated double tap connector is
inserted into the pump head of the filter, examine all three o-
rings for damage and correct fitting. Lightly grease the o-
rings with Vaseline to help installation.
Fully insert the integrated double tap connector, with the
locking clamp in an upright position, into the opening on the
pump head. To fasten the locking clamp into its sealed po-
sition, push the handle downwards.
Tubing Installation
Shut off the integrated double tap connector by shifting the
two levers to the
OFF position.
Push the enclosed tubing onto the corresponding tubing
openings of the adaptor as far as they will go, starting with the
smallest tube diameter. If this is difficult to do, soak the hoses
in warm water beforehand to make them softer.
It is very important to use original EHEIM hoses only.
off
on
off
on