Rebooting the System
There are two different ways of rebooting egnite Querx – via the web interface
(soft boot) or by interrupting the power supply (cold boot).
Please note that Querx logs every reboot along with the data its sensors
measures. They are visualized as vertical lines in the line graph (see the section
).
Soft Boot
It is sometimes required to reboot the device after changing settings. After saving
such changes, the following notification is displayed in the upper part of the
configuration area.
If you need to make further changes to the configuration, you can make them
before rebooting the system. Once you have made all the required changes, click
Reboot System
, in order to perform the reboot.
After a little while, the connection to the web interface will be re-established
automatically. However, this does not always work, for instance after changing
from HTTP to HTTPS or changing the IP address. In such cases, please enter the
new URL in the web browser.
Open the page
Maintenance / Reset
in the configuration area.
1.
Click the button
Reboot system
.
2.
Confirm the soft boot by clicking
Yes
on the following page.
103
