28
ENVIRONMENTAL REGULATIONS
When working on or with the equipment, it is imperative to observe all requirements in regards to
waste- disposal and proper recycling.
In particular during installation, repair and maintenance work, water damaging agents, such as
• lubricating grease and oil,
• hydraulic fluid,
• coolant,
• solvent containing cleaning agents
must not leak into the ground or reach the sewage system.
These materials must be stored, transported, contained and disposed of in suitable containers!
STORAGE
Unused machines and machine tools should be kept in a dry, closed room. Keep them free from damaging
influences such as damp, frost or large temperature fluctuations as well as mechanical damage.
DISPOSAL
Worn/ defect machine tools must be disposed of according to regional/ national specifications. Fully disassemble
machine for the necessary disposal.
Separate materials according to local environmental specifications.
To avoid environmental damage, hazardous material like lubricating, cooling and cleaning agents have to
disposed appropriately.
TROUBLESHOOTING
In case of disturbances check, if all instructions contained in this technical documentation are adhered to and
make the appropriate adjustment, if needed.
The following table shows possible problems and causes:
Problem
Cause
Remedy
a
Machine does not start
not connected to hydraulic
supply
Connecting and opening of
the hydraulic line
Valve not actuated
actuate valve
b
Valve lever/ pin jams
Impurities in the valve
disassemble valve parts
and clean
c
Machine turns too slowly
operation pressure too low
increase operation
pressure at the machine
adjustment device jams
disassemble motor, clean,
replace worn parts
bearing friction in the
gearbox
disassemble gear, clean,
replace worn parts
d
Motor jams
coarse dirt in the engine
bay
Disassemble motor, clean
breakage of motor parts
replace worn parts
e
Maschine makes strong
noise
friction bearing defective
disassemble machine,
clean, replace worn/
damaged parts, optimize
gear tooth system
gear tooth system too loose
If necessary, send the machine to the manufacturer.