© 2001 EFI Electronics Corporation All Rights Reserved
1
8224-0005C 11/01
The 75LC Surge Protective Device (SPD) offers surge suppression and
noise filtration for any micro-processor based product, PLC’s, Motion
Control, OEM or any critical industrial load. The SPD can be installed on
the incoming power source (20 amps or less).
INTRODUCTION
INSTALLATION
Titan 75LC
Transient Voltage Surge
Suppressor (TVSS)
Instruction Bulletin
CLICK
3
2
2
2
1
1
1
CLICK
Figure 1: DIN Rail Mounting and Removing,
Flange Mounting
NOTE: (4) Mounting Feet are included for Flange Mounting
applications.
CAUTION
HAZARD OF EQUIPMENT DAMAGE.
• Megger
®
or hi-potential tests will damage this surge protective
device. Turn off all power supplying the equipment and isolate the
surge protective device before testing.
• Not for use on ungrounded systems.
Failure to follow these precautions can result in equipment
damage.
DANGER
HAZARD OF ELECTRIC SHOCK, BURN OR EXPLOSION.
• This equipment must be installed and serviced only by qualified
electrical personnel in accordance with National and Local Electrical
Codes.
• Turn off all power supplying this equipment before working on or
inside equipment.
• Always use a properly rated voltage sensing device to confirm power
is off.
• Replace all devices, doors, and covers before turning on power to
this equipment.
• Do not apply petroleum-based products to non-metallic parts.
Failure to follow these instructions will result in death or serious
injury.