Figure 2: PS-17 connector panel
1
2
4
5
8
7
6
3
1 USB 2.0 ports (x2)
5 DVI port
2 Network port (Upper RJ-45) 6 Power button
3 Display port (for monitor)
7 Power connector
4 USB 2.0 ports (x2)
8 Power switch
Steps to integrate the PS-17 into your network
This procedure provides an overview of the steps required to integrate the PS-17 into your network and print
environment.
DANGER
Ensure all cables remain routed to prevent trip hazards and to prevent accidental disconnection or
damage. Ensure that the cables are not compressed, pinched, or bent at a sharp angle. Damaged cables
can result in electric shock to personnel, in addition to faulty operation of the equipment.
DANGER
For the power connection to the PS-17, only use the power cable provided with the PS-17. Do not use a
power cable intended for any other electronic device. It may cause fire or electrical shock.
WARNING
Use caution and correct ergonomic procedures if it is necessary to lift or move the PS-17 or connected
equipment.
CAUTION
If you are concerned about the possibility of information being extracted from the PS-17 Ethernet port
without authorization, consider securing the Ethernet port.
CAUTION
The power cable included is for this product only. Do not use the power cable for any other electronic
device.
Configuration and Setup
Integrating the PS-17 into your network
17
