39
Installation and Service Guide
Using the E-35A
Printable Info menu
This section describes how to print pages such as the Test Page and Configuration page from the Printable Info menu
(described on
). The Printable Info menu is accessed through the Fiery tab (see
Printing the
Configuration page
can be helpful during installation, Setup, and service. After installing the E-35A
(including connecting to the network), and before default settings are changed in Run Setup, you can obtain a record
of the defaults by printing the Configuration page.
Before you perform any service procedure, you should print the E-35A Configuration page, if possible, so you are
prepared to return the settings to their former configuration, if necessary.
Printing the
Test Page
indicates that the E-35A is functional and that the connection between the E-35A and the
printer is working.
To print a page from the Printable Info menu
1
If it is not powered on already, power on the printer and allow it to warm up.
2
If it is not powered on already, power on the E-35A using the power button on the front panel and allow it to start
up completely (approximately three minutes).
3
Make sure that Idle appears on the Fiery Main menu.
If Busy or Printing appears, the E-35A is processing and you must wait until Idle appears.
4
Touch the Fiery tab.
5
Touch Printable Info and then select the page that you want to print.
The E-35A sends the selected page(s) to the printer.
Restart Fiery
Shut down all E-35A activity in the correct manner and then restart. The following
options are available from the submenu that appears:
Restart Fiery Service:
Resets the server software but does not reboot the entire
system. Network access to the E-35A is temporarily interrupted and all currently
processing jobs are aborted and may be lost.
Restart System:
Shuts down and then reboots the E-35A. Network access to the E-35A
is terminated and all currently processing jobs are aborted and may be lost.
Shut Down:
Shuts down all E-35A activity properly.
