
E F A P O W E R E V - P C - I N S T A L L A T I O N A N D U S E R M A N U A L
26 | 37
7
USER MANUAL
The EFAPOWER EV-PC operation is very simple and intuitive.
During the charging process, the Human Machine Interface (HMI), presented in Chapter 3, will give instructions
and will signal different stages on Satellite module LEDs. These sequences are shown in this chapter.
7.1
OUTPUT CONNECTORS AND OUTLETS
EFAPOWER EV-PC is prepared to charge electric vehicles according to the following charging systems.
7.1.1
TYPE 2 OUTLET
Mode 3
7.1.2
TYPE 1 CONNECTOR
Mode 3
Figure 37 - Mode 3 Type 1 Connector
(output current limited to 30A)
Figure 36 - Mode 3 Type 2 Outlet
This connector is available for the
following power outputs on CE
marked units:
This connector is available for the
following power rates on CE
marked units:
This connector is also available
for the following power output on
ETL marked units: