Edwards EXT200/200H GCMS, Инструкция по эксплуатации, Страница: 19 / 38

© Edwards Limited 2013. All rights reserved. Page 13
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
B756-01-880 Issue K
3 Installation
3.1 Unpack and inspect
Take care when unpacking the pump to avoid excessive shocks that could damage the bearings and reduce the life
of the pump. The pump is supplied with the inlet and outlet sealed to prevent entry of dust and vapour. Do not
remove these seals until the pump is installed on the vacuum system.
Open the top of the packaging by disengaging the cardboard tabs and then opening the lid. Remove the top piece of
locating foam and any ancillaries included within the box. Remove the pump from the packaging by lifting the pump
vertically from the packaging. If the pump is damaged, notify the supplier and the carrier in writing within three
days; state the Item Number of the pump together with the order number and the supplier’s invoice number. Retain
all packing materials for inspection. Do not use the pump if it is damaged.
Check that the package contains the items listed in Table 5 . If any of these items is missing, notify the supplier in
writing within three days.
If the pump is not to be used immediately, store the pump in suitable conditions as described in Section 6.1 .
Do not discard the packing materials; retain them to re-package the pump if it is returned for service.
3.2 Typical installation
CAUTION
Local legislation concerning the impact of the pump on the environment must be followed when installing the
pump.
WARNING
The pump weighs approximately 9 kg (20 lbs). Appropriate care should be taken when lifting and
moving the pump to avoid injury.