Edwards D397-01-000, Инструкция по эксплуатации

Страница: 44 / 56

D397-01-880 Issue E
Page 36 © Edwards Limited 2016. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Operation

Display contrast allows the user to change the contrast of the display.

Protocol shows whether RS232 or RS485 is being used.

Comms address - To set the comms address of the TIC.
4.13 Screen options
The user can use this screen to choose what order information is displayed on the view screen. The options include:

Show all gauges - This shows all the gauges in 1X height.

Show three gauges - This shows 3 gauges at a time in 2X height. The user can scroll to all the gauges set up to
be viewed.

Three gauge order - The user can set the order which gauges are shown.

Show one gauge - Show 1 gauge at a time in 3X height. The user can scroll to all the gauges set up to be
viewed.

One gauge order - The user can set the order which gauges are shown.
4.13.1 Organising gauges on the view screen
The three gauge order and one gauge order functions are used to set up what gauges and in what order the gauges
are shown on the view screen. In the following example the user wants to set the order below:

Position 1: The gauge plugged into the ‘gauge 1’ connection.

Position 2: The gauge plugged into the ‘gauge 5’ connection.

Position 3: The gauge plugged into the ‘gauge 2’ connection.

Position 4: The gauge plugged into the ‘gauge 3’ connection.

Position 5: A gauge is not plugged into the ‘gauge 4’ connection, the user does not want Position 5 to be
shown on the screen. The No gauge selection has been made.

Position 6: A gauge is not plugged into the ‘gauge 6’ connection, the user does not want Position 6 to be
shown on the screen. The No gauge selection has been made.
Figure 27 - Gauge order set up
Note: The user can set up different ordering, to show three gauges or one gauge.
Once the set up is complete and the user views the screen, the gauge setup at position one is shown first. The user
can scroll around to all the other gauges set up in the positions defined. In the example above, only 4 positions can
be scrolled to as the user has chosen that positions 5 and 6 will not be shown when returning to the main view screen.
gea/d39701/