Edsyn LONER ATMOSCOPE 971HAe, Инструкция по эксплуатации, Страница: 5 / 10

1.
Place Quadra-Flow Tips over the SMD.
2. After waiting for the solder to melt, twist
tool gently to see if the SMD is free.
3. Remove SMD by using a pair of tweezers.
4. To resolder, glue SMD to the board with
the leads aligned with the pads.
5. Place Quadra-Flow Tip over SMD and allow
solder to reflow
Use WT620 Socket Wrench to install Tips
with RN432 or RN433 Retaining Nut
WT620
RN432
Part No. and Description Width Length Package
.26”
(6.6mm)
.41”
(10.4mm)
SO-16
.32”
(8.1mm)
.45”
(11.4mm)
LCCC-18R
.34”
(8.6mm)
.55”
(14.0mm)
PLCC-18
.44”
(11.2mm)
.48”
(12.2mm)
SO-18L
.66”
(16.8mm)
.90”
(22.9mm)
QFP-100
.77”
(19mm)
1.0”
(25.4mm)
SMT Hot Air Quadra-Flow Tips
LT449 LONER SMD Quadra-Flow Hot Air Tip
LT478* LONER SMD Quadra-Flow Hot Air Tip
LT462*
LONER SMD Quadra-Flow Hot Air Tip
LT451* LONER SMD Quadra-Flow Hot Air Tip
LT468**
LONER SMD Quadra-Flow Hot Air Tip
LT477** LONER SMD Quadra-Flow Hot Air Tip
______
* Comes with RN432 Retaining Nut for Small Quadra-Flow Tips
** Comes with RN433 Retaining Nut for Large Quadra-Flow Tips
Bendable Hot Air Tips
LT571* LONER SMD Bendable Hot Air Tip LT572* LONER SMD Bendable Hot Air Tip
* Includes WT624 Tip Wrench
Using the WT624 these Tips can be
bent to accommodate most SMD sizes
Using Quadra-Flow Tips
(Recommended for Four Side Leaded Components)
Quadra-Flow Tips come in a variety of sizes. Increase air output as you increase the size of the Tip.
WT624
Quadra-Flow Tips
create an “oven like”
condition around the
SMD.
RN433
Retainer Nut