E D R O
D
y n a
W
a s h
®
T
h r e e
P
o c k e T
W
a s h e r
- e
x T r a c T o r s
16
Tighten shock nuts snug at upper and lower locations. DO NOT CRUSH THE RUBBER
BUSHINGS!
Main spring shafts should have two (2) full threads extending beyond lower locks nuts to
ensure proper locking action.
To achieve the required operating clearance or if leveling is required, first determine which
spring assembly is out of level, then loosen the locking nut and either tighten or loosen the
adjusting nut located on the threaded rod at the top of the main spring shaft assembly.
Perform this operation in intervals of two (2) full turns at a time to compress or release the
reverse loaded coil spring. Repeat as necessary. Once level, tighten the lock nut. For
optimum performance, DynaWash
®
washer-extractors should be level left to right, as well as
front to back. Minimum distance from the bottom of the front and rear plate to the top of the
base plate is 1-
1
⁄
4
” (3.175 cm).
•
•
•
The
PassThru
option of DynaWash
®
machines, DW_PT and DW_PTSM, differs from the other
models by its construction allowing the machine to be loaded from one side and unloaded from
the other. The operation and the performance of these machines are identical with the standard
end loading DynaWash
®
units.
PassThru
units require the installation of the clean side seal.
The superstructure of the clean side seal goes between clean side of unit and barrier wall. The
clean side plate of the machine has bolts studded to it to assist in assembly of the barrier
material from the machine to the barrier wall.
PASSTHRU
MODELS (DW_PT & DW_PTSM)
It is vitally necessary to provide a proper foundation for DynaWash
®
machines. Anchor the
machine to the floor by either pouring a new foundation in accordance with factory specifications
or install on existing floor. In either case, the foundation should be constructed of 5,000 PSI
re-enforced concrete. For installations on upper floors, check with a structural engineer to verify
the capability of the floor to support the machine’s static weight and forces once in operation.
For best machine performance, it is recommended that DynaWash
®
straddle a drain trough,
unless the drain to rear option is ordered in which case the machine should be piped directly to
a sewer drain. The drain trough should have a capacity to sustain the maximum amount of
water for all machines at the site if all washers were to simultaneously drain from their high
water level.
Minimum foundation requirements can be found on the following charts. For reference, the
minimum foundation requirement for Dyna
Mount Soft Mount models (DW_SM & DW_PTSM)
is ability of floor to support the static weight of a fully loaded machine taking into account a 5%
variance for vibration deflection. Variations may be made to suit a specific installation as long
as minimum and/or maximum requirements are met.
FOUNDATION