EdilKamin 812740-1139210, Руководство пользователя, Страница: 76 / 80

76
17. ADVICE FOR POSSIBLE PROBLEMS
In the event of problems, the product automatically performs the shutdown operation.
The display shows the reason (see below).
17.1. Display messages
MESSAGE PROBLEM ACTIONS
A01 It is shown if the combustion air intake flow rate
falls below a preset level Check that the firebox door is closed
Check that regular maintenance has
been performed on the stove
Check that the smoke discharge and
combustion air intake duct are clean.
A02 It is shown if the motherboard does not detect
the correct smoke fan speed Contact the technician
A03
It is shown if the thermocouple detects a
smoke temperature lower than a set value,
interpreting this as absence of flame Check that there are enough pellets in
the hopper
Check that the water temperature has
not risen due to some valve being closed
(contact the technician)
Contact the technician
A04 It is shown if ignition is not successful within
the set time Distinguish between the following two
cases:
The flame has NOT appeared:
Make sure that the crucible is in the
correct position and check that it is clean
Check for the presence of pellets in the
hopper and in the crucible
Try lighting with a solid ecological lighter
(contact the technician first and follow
the
instructions of the lighter
manufacturer very carefully). The
operation should be considered as a test
only, under the guidance of the
technician.
A05 Switch-off due to broken air flow rate sensor Contact the technician
A06 It is shown if the electronic motherboard
detects that the smoke temperature probe is
broken or disconnected Contact the technician