SELECTING CHEMICAL ON OPTIONAL
991RS (NOT INCLUDED):
Use the chemical selector valve to change between the
left side and right side bottle holders. For accurate flow
rates, point the selector valve straight at the bottle holder
you wish to draw from. Place the selector valve at top
dead center to close the injector system. The system will
not draw chemical in the closed position.
LEFT BOTTLE
RIGHT BOTTLE
CLOSED
USING OPTIONAL 9000AC SPRAYER
(NOT INCLUDED):
Use the spray collar to select between low pressure chem-
ical application or high pressure rinse. Pop “OUT” for
low pressure and “IN” for high pressure.
You may also adjust the angle of spray from a concen-
trated stream to a wider pattern by rotating the spray
collar clockwise or counter-clockwise.
Note: Chemical cannot be applied in the high
pressure rinse mode.
TOUCH-LESS HARD SURFACE CLEANING
USING THE 991RS CHEMICAL INJECTOR
SYSTEM ON THE ENDEAVOR:
Use the following instructions as a basic guideline to
clean hard surfaces using the ENDEAVOR and the
991RS system.
1. Select the appropriate tip and install on the intake
cap.
2. Place bottles into the bottle holders.
3. Select chemical using chemical selector valve.
4. Take the feed tube attached to the intake cap and
place it inside the bottle. Thread the intake cap onto
the bottle.
1. Plug in power cords as per instructions on page 6.
2. Make sure you are on 2 circuits.
3. Connect your solution hose to machine and 9000AC
High Pressure
Low Pressure
15