EdgeMarc 4576 Enterprise Session Border Controller Installation Guide
8
Connecting to the LAN
1. Connect one end of an Ethernet cable to local LAN port 1 on the front panel of the
EdgeMarc 4576 (shown as C in the front panel diagram).
2.
Connect the other end of the cable to your computer’s Ethernet port.
Connecting to a WAN Router, Cable Modem or DSL Modem
1. Connect the Ethernet cable to the Ethernet WAN port on the EdgeMarc 4576
(shown as D in the front panel diagram).
2. Connect the other end to an Ethernet port to the Ethernet port on a router or a
modem.
Step 3: Install the Amphenol Connector
The EdgeMarc 4576 includes 24 integrated Phone/FXS ports for connecting analog
and key system phones to the network. The Phone/FXS ports require a male 50-pin
Amphenol type connector (90 degree or 180 degree). Refer to the following diagrams:
