6-27
•
Benthos describes their frequencies as in-band codes and
out of band codes.
The out-of-band code is always 12.5
KHz
. The in-band codes can be seen in the table below or on
the label on the release.
•
The "In Band Code" or frequency is the same for the
command and the interrogate pulse.
5.
When the frequency is set, press the Enter Button
on the keypad to advance the Benthos
Command Menu display to a second screen where a
REPETITION RATE code
is set.
Figure 6-6: 8011M Benthos Instructions- REPETITION RATE Code Display
6.
A
REPETITION RATE code
is set by pressing the up and down buttons on the keypad to manipulate
one letter of the two-character code value located on the bottom right side of the digital display.
Figure 6-7: 8011M Benthos Instruction- Setting REPETITION RATE code
