1
1
Install Caster Wheels
Make sure unit is empty (including white metal keg floor(11). Carefully
tip the beer dispenser on its side. Connect the casters(13) to the cabinet
by screwing in each metal bracket into one of four caster holes (casters
in the front of the cabinet require the washers). Then carefully set the
unit upright
Note: allow dispenser to stand in an upright position for 8 hours
before turning on the power.
2
Remove Plug
Carefully remove the top cabinet plug located on the top of the unit
by opening the cabinet, and with your hand, push plug through the
top of the cabinet from the inside. Use flat head screwdriver as a
prying tool if necessary.
3a
Install Tower
Now begin installing the tower(3). Unravel the beer line hose from the
bottom of the tower, and feed the hex nut and beer line through the
hole you uncovered in the top of the cabinet.
3b
Secure Tower
Once you have fed all the line into the cabinet, you can now place the
tower on the unit and screw into place.
4
Install Railing
Take the railing(4) and
slide its “feet” into the
pilot holes in the top of
the cabinet
Thank you for purchasing the EdgeStar Beer Dispenser.
Are you ready to enjoy some draft beer now?
All you need is:
• Included components (pictured to the left)
• Wrench
• Flat head screwdriver
• Pair of pliers/clamp crimper
• Full keg of beer (1/2 barrel size or smaller [pictured to the left but not included])
• Also, fill the included CO
2
tank with CO
2
(Most beer keg providers can fill your CO2 tank)
Notice: this manual is provided as a supplement to the owner’s manual. Please refer to the
owner’s manual for a full discourse on installation, usage and maintenance.
1. Faucet Handle
2. Faucet
3. Beer Tower
4. Guard Rail
5. Drip Tray
6. Regulator
7.
CO
2
Tube
8.
CO
2
Cylinder (supplied empty)
9. Beer Hose
10. American Sankey Keg Coupler
11. Metal Keg Floor Support
12. Caster Washer (x2)
13. Casters (color may vary) (x4)
14. Neoprene Washer
15. Snap-On Clamps (color may vary) (x2)
16. Half Barrel Keg (not included)
17. Spanner Wrench
Warning
CO
2
can be dangerous! CO
2
cylinders contain high-pressured gas, which can be
hazardous if handled improperly. Please handle with care.
Warning:
This guide is provided for informational purposes only. If you have any questions about
the installation of this appliance, feel free to contact EdgeStar service at 866.319.5473 or consult
a qualified installer. Neither the manufacturer nor its distributors shall be liable for any incidental,
consequential, indirect, special, or punitive damages of any nature, including without limitation,
lost revenues or profits, or any other damage whether based in contract, tort, or otherwise.
1
2
3
4
6
7
10
8
5
9
11
12
13
14
15
17
18
Parts List
Note: Unit ships with extra parts from the manufacturer. Please use only the parts listed above.
Installation Guide
Beer Dispenser
866-319-5473
For assistance, please call:
