8
Installation
The kegerator should be installed in accordance with local electrical code requirements. The kegerator
should also be placed in a location that is strong enough to support its total weight, keeping in mind that
it will weigh substantially more when fully loaded than when empty.
Before you plug the kegerator
into a power supply, be sure to let it stand upright for at least 24 hours to allow the compressor’s
oils to settle.
Unpacking the Kegerator
Warning:
Use two or more people to move and install the kegerator. Failure to do so
can result in back or other injury. Carefully remove the packaging materials. Remove any
shipping tape and glue from your kegerator before use. Do not use sharp instruments,
rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your kegerator.
!
Warning:
Do not remove any safety, warning, or product information labels from your
kegerator.
!
This kegerator has been designed for freestanding installation. This will allow you to install the kegerator
in almost any place you desire. You must follow the stated instructions for electrical requirements and
leveling the kegerator.
Notes:
• This unit MUST be installed in an area protected from the elements, e.g. wind, rain,
water spray, or drips.
• The kegerator should not be located in direct sunlight, next to ovens, grills, or other heat
sources.
• Do not kink or pinch the power supply cord between the kegerator and the wall or
cabinet.
!
Clearance Requirements
To ensure the kegerator will last, install it in a location where there is proper air circulation and electrical
connections. This kegerator is designed for indoor use only and should not be used outdoors. It should
not be placed in a built-in or recessed area as it is designed to be a freestanding kegerator. The
Kegerator should allow a minimum of 2” on the sides and 4” in the back.
4-5”
2-3”
2-3”
4-5”
Top View:
Side View:
