EdgeStar BIDW18BL -1, Руководство пользователя

Страница: 25 / 34

21
Starting the Wash Cycle
Once the dishwasher is fully loaded, follow these procedures to start
the wash cycle:
 Ensure that the unit is connected to the power supply.
 Ensure that the water supply is turned on to full pressure.
 Pour in the detergent. Also, ensure that there is adequate rinse aid.
 Press the ON/OFF switch to power the dishwasher on.
 Rotate the knob to the desired cycle. The wash cycle will be
changed as following direction:
Heavy -> Normal -> Light -> Glass -> Speed -> Rinse
 Press the START/PAUSE button. After 10 seconds, the program will
start.
NOTE:
When the START/PAUSE button is pressed during a wash cycle the
cycle is suspended and the program light will stop blinking. Unless the
START/PAUSE button is pressed to continue the cycle, an indicator
beep will be heard every minute.
Changing the Cycle
You can modify the wash cycle, but only if the dishwasher has been
running for a short time. Otherwise, detergent may have already been
released, and the appliance may have already drained the wash
water. If this is the case, the detergent dispenser must be refilled.
Holding the START/PAUSE button for three (3) seconds will cancel the
current program.
Opening the door during the wash cycle may result in injury
from scalding hot water.
NOTE:
If the door is opened during the wash cycle, the machine will be
paused. When the door is closed, the machine will restart after 10
seconds.
Forget to Add a Dish?
A dish can be added any time before the detergent cup opens.
1. Press the START/PAUSE button.
2. Open the door slightly to stop the washing.
3. You can open the door completely after the spray arms stop
spinning.
4. Add remaining dishes.
5. Close the door.
6. Press the START/PAUSE button.
The dishwasher will restart after 10 seconds.