7TH BUILDING, NO.59 CHUANG FU ROAD,XIAO GANG
INDUSTRIAL ZONE, NINGBO 315800, CHINA
Tel +86.574.873.88888 Fax +86.574.876.77777
www.edgeholdings.com
Bluetooth
®
Audio Receiver
BTR-12
Design Features And Functions
Rear Flush Mount Instructions
Note
Important
Drilla 1 1/8" (30mm) diameter hole.
There are two grommets remove one and leave one in place.
Feed the wires and the threaded protion throuth the hole,place on the second grommet and screw the
nut back into place until tightly installed
The orientation of the unit can be adjusted in either of the mounting positions simply by loosening the unit
at the back and rotating the device.
Never attempt to open, repair, or modify any part of the unit doing So will void all warranty.
You should open, remove the fuse, and leave the cap open on the fuse holder to feed it through the
hole.
Check local laws regarding the use of a mobile phone and a handsfree kit while
driving. If you use the Bluetooth® unit while driving, ensure your attention and focus remains on your
responsibility of driving safely.
Turning Unit - ON / OFF
Connect Yellow Wire (B+) 12V Battery and Black Wire (B-) 12V Ground securely,
Press button and hold it for over 3 seconds until you see the blue LED light goes out (OFF) or stays lit for
(ON).
Previous
Play/Pause
Next
Blue LED Blinking - Pairing Mode
Blue LED Solid - Paired
VOL -
Power on/off
VOL +
Red -(B+)- 12V Ignition/Accessory Power
Black -(B-) 12V Ground
Blue/White Stripe - Amplifier Remote Turn on
Yellow - (B+) - 12V Battery/Constant/Fused Power
AUX Audio Input - Red 3.5mm Connector
RCA Audio Output(to Amp)
