Edge-Core ES3510MA-DC, Руководство по управлению, Страница: 844 / 1098

C
HAPTER
35
| VLAN Commands
Configuring IEEE 802.1Q Tunneling
– 844 –
E
XAMPLE
This example sets the SVID to 99 in the outer tag for egress packets
exiting port 1 when the packet’s CVID is 2.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel service 99 match cvid 2
Console(config-if)#
In the following examples, ports 1 and 2 are configured as follows:
Port 1 = Access, PVID = 100, VLAN = 100(u), 101(u)
Port 2 = Uplink, VLAN = 100(t), 101(t)
1. Inject tagged frame (VID=10) to Port 1, then
=> Port 2: exits double-tagged frame (SVID=100, CVID=10)
( switching )
2. Port 1: switchport dot1q-tunnel service 101 match cvid 10
Inject tagged frame (VID=10) to Port 1, then
=> Port 2: exits double-tagged frame (SVID=101, CVID=10)
( ingress vlan translation )
Inject double-tagged frame (SVID=101, CVID=10) to Port 2, then
=> Port 1: exits single-tagged frame (VID=10)
( switching )
3. Port 1: switchport dot1q-tunnel service 101 match cvid 10 remove-ctag
Inject tagged frame (VID=10) to Port 1, then
=> Port 2: exits single-tagged frame (SVID=101)
( ingress vlan translation )
Inject single-tagged frame (SVID=101) to Port 2, then
=> Port 1: exits single-tagged frame (VID=10)
( egress vlan translation )
switchport dot1q-
tunnel tpid
This command sets the Tag Protocol Identifier (TPID) value of a tunnel
port. Use the no form to restore the default setting.
S
YNTAX
switchport dot1q-tunnel tpid tpid
no switchport dot1q-tunnel tpid
tpid – Sets the ethertype value for 802.1Q encapsulation. This
identifier is used to select a nonstandard 2-byte ethertype to
identify 802.1Q tagged frames. The standard ethertype value is
0x8100. (Range: 0800-FFFF hexadecimal)
D
EFAULT
S
ETTING
0x8100