Edge-Core ECS4120-28F, Справочное руководство, Страница: 73 / 938

– 73 –
2
Using the Command Line
Interface
This chapter describes how to use the Command Line Interface (CLI).
Accessing the CLI
When accessing the management interface for the switch over a direct connection
to the server’s console port, or via a Telnet or Secure Shell connection (SSH), the
switch can be managed by entering command keywords and parameters at the
prompt. Using the switch's command-line interface (CLI) is very similar to entering
commands on a UNIX system.
Console Connection
To access the switch through the console port, perform these steps:
1.
At the console prompt, enter the user name and password. (The default user
names are “admin” and “guest” with corresponding passwords of “admin” and
“guest.”) When the administrator user name and password is entered, the CLI
displays the “Console#” prompt and enters privileged access mode
(i.e., Privileged Exec). But when the guest user name and password is entered,
the CLI displays the “Console>” prompt and enters normal access mode
(i.e., Normal Exec).
2.
Enter the necessary commands to complete your desired tasks.
3.
When finished, exit the session with the “quit” or “exit” command.
After connecting to the system through the console port, the login screen displays:
User Access Verification
Username: admin
Password:
CLI session with the ECS4120-28T is opened.
To end the CLI session, enter [Exit].
Console#
Telnet Connection
Telnet operates over the IP transport protocol. In this environment, your
management station and any network device you want to manage over the
network must have a valid IP address. Valid IP addresses consist of four numbers, 0
to 255, separated by periods. Each address consists of a network portion and host