Edge-Core ECS4120-28F, Справочное руководство, Страница: 464 / 938

Chapter 15
| Congestion Control Commands
Automatic Traffic Control Commands
– 464 –
Command Usage
After the apply timer expires, a control action may be triggered as specified by the
auto-traffic-control action command and a trap message sent as specified by the
snmp-server enable port-traps atc broadcast-control-apply command or snmp-
server enable port-traps atc multicast-control-apply command.
Example
This example sets the apply timer to 200 seconds for all ports.
Console(config)#auto-traffic-control broadcast apply-timer 200
Console(config)#
auto-traffic-control
release-timer
This command sets the time at which to release the control response after ingress
traffic has fallen beneath the lower threshold. Use the
no form to restore the
default setting.
Syntax
auto-traffic-control { broadcast | multicast } release-timer seconds
no auto-traffic-control { broadcast | multicast } release-timer
broadcast - Specifies automatic storm control for broadcast traffic.
multicast - Specifies automatic storm control for multicast traffic.
seconds - The time at which to release the control response after ingress
traffic has fallen beneath the lower threshold. (Range: 1-900 seconds)
Default Setting
900 seconds
Command Mode
Global Configuration
Command Usage
This command sets the delay after which the control response can be terminated.
The
auto-traffic-control auto-control-release command must be used to enable or
disable the automatic release of a control response of rate-limiting. To re-enable a
port which has been shut down by automatic traffic control, you must manually re-
enable the port using the
auto-traffic-control control-release command.
Example
This example sets the release timer to 800 seconds for all ports.
Console(config)#auto-traffic-control broadcast release-timer 800
Console(config)#