Edge-Core ECS4110-28T, Руководство по управлению, Страница: 1317 / 1514

C
HAPTER
40
| Multicast Filtering Commands
MVR for IPv6
– 1317 –
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
The following displays the profiles bound to domain 1:
Console#show mvr6 domain 1 associated-profile
Domain ID : 1
MVR Profile Name Start IPv6 Addr. End IPv6 Addr.
-------------------- ------------------------- -------------------------
rd ff01::fe ff01::ff
Console#
show mvr6 interface
This command shows MVR configuration settings for interfaces attached to
the MVR VLAN.
S
YNTAX
show mvr6 [ domain domain-id ] interface
domain-id - An independent multicast domain. (Range: 1-5)
D
EFAULT
S
ETTING
Displays configuration settings for all attached interfaces.
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
The following displays information about the interfaces attached to the
MVR6 VLAN in domain 1:
Console#show mvr6 domain 1 interface
MVR6 Domain : 1
Port Type Status Immediate Leave Static Group Address
-------- -------- ------------------- ---------------- ---------------------
Eth1/ 1 Source Active/Forwarding
Eth1/ 2 Receiver Active/Forwarding Disabled ff00::1(VLAN2)
Console#
Table 184: show mvr6 interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for source
ports is “ACTIVE” if MVR is globally enabled on the switch. MVR status
for receiver ports is “ACTIVE” only if there are subscribers receiving
multicast traffic from one of the MVR groups, or a multicast group has
been statically assigned to an interface.