Edge-Core ECS4110-28T, Руководство по управлению, Страница: 1222 / 1514

C
HAPTER
39
| Quality of Service Commands
– 1222 –
E
XAMPLE
This example creates a policy called “rd-policy,” uses the class command to
specify the previously defined “rd-class,” uses the set phb command to
classify the service that incoming packets will receive, and then uses the
police flow command to limit the average bandwidth to 100,000 Kbps, the
burst rate to 4000 bytes, and configure the response to drop any violating
packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set phb 3
Console(config-pmap-c)#police flow 100000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
service-policy
This command applies a policy map defined by the policy-map command
to the ingress side of a particular interface. Use the no form to remove this
mapping.
S
YNTAX
[ no ] service-policy input policy-map-name
input - Apply to the input traffic.
policy-map-name - Name of the policy map for this interface.
(Range: 1-32 characters)
D
EFAULT
S
ETTING
No policy map is attached to an interface.
C
OMMAND
M
ODE
Interface Configuration (Ethernet)
C
OMMAND
U
SAGE
◆
Only one policy map can be assigned to an interface.
◆
First define a class map, then define a policy map, and finally use the
service-policy command to bind the policy map to the required
interface.
◆
The switch does not allow a policy map to be bound to an interface for
egress traffic.
E
XAMPLE
This example applies a service policy to an ingress interface.
Console(config)#interface ethernet 1/1
Console(config-if)#service-policy input rd-policy
Console(config-if)#