Edge-Core ECS4110-28T, Руководство по управлению, Страница: 1141 / 1514

C
HAPTER
36
| ERPS Commands
– 1141 –
C
OMMAND
U
SAGE
◆
Two steps are required to make a ring operating in non-revertive mode
return to Idle state from forced switch or manual switch state:
1.
Issue an erps clear command to remove the forced switch
command on the node where a local forced switch command is
active.
2.
Issue an erps clear command on the RPL owner node to trigger the
reversion.
◆
The erps clear command will also stop the WTR and WTB delay timers
and reset their values.
◆
More detailed information about using this command for non-revertive
mode is included under the Command Usage section for the non-
revertive command.
E
XAMPLE
Console#erps clear domain r&d
Console#
erps forced-switch
This command blocks the specified ring port.
S
YNTAX
erps forced-switch [ domain ring-name ] { east | west }
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
east - East ring port.
west - West ring port.
C
OMMAND
M
ODE
Privileged Exec
C
OMMAND
U
SAGE
◆
A ring with no pending request has a logical topology with the traffic
channel blocked at the RPL and unblocked on all other ring links. In this
situation, the erps forced-switch command triggers protection
switching as follows:
a.
The ring node where a forced switch command was issued blocks
the traffic channel and R-APS channel on the ring port to which the
command was issued, and unblocks the other ring port.
b.
The ring node where the forced switch command was issued
transmits R-APS messages indicating FS over both ring ports. R-APS
(FS) messages are continuously transmitted by this ring node while
the local FS command is the ring node’s highest priority command
(see Table 140 on page 1142 ). The R-APS (FS) message informs