Edge-Core ECS4110-28T, Руководство по управлению, Страница: 1140 / 1514

C
HAPTER
36
| ERPS Commands
– 1140 –
C
OMMAND
M
ODE
ERPS Configuration
C
OMMAND
U
SAGE
If the switch goes into ring protection state due to a signal failure, after the
failure condition is cleared, the RPL owner will start the wait-to-restore
timer and wait until it expires to verify that the ring has stabilized before
blocking the RPL and returning to the Idle (normal operating) state.
E
XAMPLE
Console(config-erps)#wtr-timer 10
Console(config-erps)#
clear erps statistics
This command clears statistics, including SF, NR, NR-RB, FS, MS, Event,
and Health protocol messages.
S
YNTAX
clear erps statistics [ domain ring-name ]
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
C
OMMAND
M
ODE
Privileged Exec
E
XAMPLE
Console#clear erps statistics domain r&d
Console#
erps clear
This command manually clears the protection state which has been
invoked by a forced switch or manual switch command, and the node is
operating under non-revertive mode; or before the WTR or WTB timer
expires when the node is operating in revertive mode.
S
YNTAX
erps clear domain ring-name
ring-name - Name of a specific ERPS ring. (Range: 1-12 characters)
C
OMMAND
M
ODE
Privileged Exec