Edge-Core ECS2000-26T, Руководство по установке

Страница: 40 / 65

C
HAPTER
3
| Installing the Switch
Mounting
– 40 –
C
ONNECTING TO A
P
OWER
S
OURCE
To connect a switch to a power source:
1.
Insert the power cable plug directly into the AC inlet located at the back of
the switch.
Figure 14: Power Inlet
2.
Plug the other end of the cable into a grounded, 3-pin, AC power source.
3.
Check the front-panel LEDs as the device is powered on to be sure the
Power LED is on green. If not, check that the power cable is correctly
plugged in.
N
OTE
:
For International use, you may need to change the AC line cord.
You must use a line cord set that has been approved for the wall socket
type in your country.