Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 882 / 1116

Chapter 29
| IP Routing Commands
Open Shortest Path First (OSPFv3)
– 882 –
General Configuration
router ipv6 ospf
This command creates an Open Shortest Path First (OSPFv3) routing process and
enters router configuration mode. Use the
no form to disable OSPF for all processes
or for a specified process.
Syntax
[ no ] router ipv6 ospf [ tag process-name ]
process-name - A process name must be entered when configuring multiple
routing instances. (Range: Alphanumeric string up to 16 characters)
Command Mode
Global Configuration
Default Setting
Disabled
Command Usage
◆
This command is used to enable an OSPFv3 routing process, and to enter router
configuration mode.
◆
The process-name is only used on the local router to distinguish between
different routing processes. It should not be confused with the instance-id
configured with the ipv6 router ospf area command which is used to
distinguish between different routing processes running on the same link-local
network segment.
Example
Console(config)#router ipv6 ospf tag 0
Console(config-router)#end
Console#show ipv6 ospf
Routing Process "ospf r&d" with ID 192.168.0.2
Process uptime is 1 hour 34 minutes
Supports only single TOS(TOS0) routes
SPF schedule delay 5 secs, Hold time between two SPFs 10 secs
Number of incoming concurrent DD exchange neighbors 0/5
Number of outgoing concurrent DD exchange neighbors 0/5
Number of external LSA 0. Checksum 0x000000
Number of opaque AS LSA 0. Checksum 0x000000
Number of LSA received 0
Number of areas attached to this router: 1
Area 0.0.0.0 (BACKBONE)
SPF algorithm executed 1 times
Number of LSA 2. Checksum 0x00ab4f
Console#
Related Commands
ipv6 router ospf area (893)