Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 828 / 1116

Chapter 29
| IP Routing Commands
Routing Information Protocol (RIP)
– 828 –
timers basic
This command configures the RIP update timer, timeout timer, and garbage-
collection timer. Use the
no form to restore the defaults.
Syntax
timers basic update timeout garbage
no timers basic
update – Sets the update timer to the specified value.
(Range: 5-2147483647 seconds)
timeout – Sets the timeout timer to the specified value. (Range: 90-360
seconds)
garbage – Sets the garbage collection timer to the specified value.
(Range: 60-240 seconds)
Default Setting
Update: 30 seconds
Timeout: 180 seconds
Garbage collection: 120 seconds
Command Mode
Router Configuration
Command Usage
◆
The update timer sets the rate at which updates are sent. This is the
fundamental timer used to control all basic RIP processes.
◆
The timeout timer is the time after which there have been no update messages
that a route is declared dead. The route is marked inaccessible (i.e., the metric
set to infinite) and advertised as unreachable. However, packets are still
forwarded on this route.
◆
After the timeout interval expires, the router waits for an interval specified by
the garbage-collection timer before removing this entry from the routing table.
This timer allows neighbors to become aware of an invalid route prior to it
being purged by this device.
◆
Setting the update timer to a short interval can cause the router to spend an
excessive amount of time processing updates.
◆
These timers must be set to the same values for all routers in the network.
Example
This example sets the update timer to 40 seconds. The timeout timer is
subsequently set to 240 seconds, and the garbage-collection timer to 160 seconds.
Console(config-router)#timers basic 15
Console(config-router)#