Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 426 / 1116

Chapter 14
| Loopback Detection Commands
– 426 –
Command Usage
◆
When the loopback detection mode is changed, any ports placed in shutdown
state by the loopback detection process will be immediately restored to
operation regardless of the remaining recover time.
◆
If the recovery time is set to zero, all ports placed in shutdown state can be
restored to operation using the
loopback-detection release command. To
restore a specific port, use the no shutdown command.
Example
Console(config)#loopback-detection recover-time 120
Console(config-if)#
loopback-detection
transmit-interval
This command specifies the interval at which to transmit loopback detection
control frames. Use the
no form to restore the default setting.
Syntax
loopback-detection transmit-interval seconds
no loopback-detection transmit-interval
seconds - The transmission interval for loopback detection control frames.
(Range: 1-32767 seconds)
Default Setting
10 seconds
Command Mode
Global Configuration
Example
Console(config)#loopback-detection transmit-interval 60
Console(config)#
loopback detection
trap
This command sends a trap when a loopback condition is detected, or when the
switch recovers from a loopback condition. Use the
no form to restore the default
state.
Syntax
loopback-detection trap [ both | detect | none | recover ]
no loopback-detection trap
both - Sends an SNMP trap message when a loopback condition is
detected, or when the switch recovers from a loopback condition.