Edge-Core AS5700-54X, Справочное руководство CLI, Страница: 182 / 1116

Chapter 5
| SNMP Commands
General SNMP Commands
– 182 –
General SNMP Commands
snmp-server
This command enables the SNMPv3 engine and services for all management clients
(i.e., versions 1, 2c, 3). Use the
no form to disable the server.
Syntax
[ no ] snmp-server
Default Setting
Enabled
Command Mode
Global Configuration
show snmp user Shows the SNMP users PE
show snmp view Shows the SNMP views PE
Notification Log Commands
nlm Enables the specified notification log GC
snmp-server notify-filter Creates a notification log and specifies the target host GC
show nlm oper-status Shows operation status of configured notification logs PE
show snmp notify-filter Displays the configured notification logs PE
Transceiver Power Threshold Trap Commands
transceiver-threshold
current Sends a trap when the transceiver current falls outside the
specified thresholds IC (Port)
transceiver-threshold
rx-power Sends a trap when the power level of the received signal
falls outside the specified thresholds IC (Port)
transceiver-threshold
temperature Sends a trap when the transceiver temperature falls
outside the specified thresholds IC (Port)
transceiver-threshold
tx-power Sends a trap when the power level of the transmitted signal
power outside the specified thresholds IC (Port)
transceiver-threshold
voltage Sends a trap when the transceiver voltage falls outside the
specified thresholds IC (Port)
Additional Trap Commands
memory Sets the rising and falling threshold for the memory
utilization alarm GC
process cpu Sets the rising and falling threshold for the CPU utilization
alarm GC
show memory Shows memory utilization parameters PE
show process cpu Shows CPU utilization parameters PE
Table 29: SNMP Commands
(Continued)
Command Function Mode