EN
45
Changing the spring
(fig. 11)
After you have removed the drum, you have to
remove the spring guard (7) and then remove the
spring (8) from its seat in the housing (9).
Lubricate the spring
and set it along with the guard and disc on its seat
according to the instructions described above.
Starter system
The electronic starter system consists of:
1 - Magnetic flywheel - 2 - Coil - 3 - Spark plug
Figure 12
The coil on the outside of the flywheel must be
fastened with three screws, 0.3 mm away from the
flywheel (measured on the magnets).
The distance between the electrodes of the spark
plug must be 0.5 mm.
To ensure good operating reliability, the spark plug
must be cleaned and checked at least once per
week. The spark plugs of the 2-cycle motors have a
relatively short service life. They must be changed
once each month.
Use
original spark plugs Eder A56 (art. no.:
310121)
Information
To check the starter without removing the flywheel,
you have to remove the spark plug and check
whether the removed spark plug and the body of
the motor are making contact. Then tighten the
starter handle.
Motor maintenance
The motor was set and tested on the workbench at
the factory.
During the first 10-15 operating hours, the chainsaw
must never be subjected to a heavy load for a long
time.
Caution
Keep the air openings, lines and air filter clean.
Using a brush or compressed air, regularly remove
dust and dirt from the slits, cylinder cover and fins
of the cylinder to prevent the motor from
overheating.
Carry out all maintenance instructions described
above. Clean the device thoroughly and lubricate
the metal parts. Empty the carburettor tank and let
the motor run until there is no more fuel. Store the
device in a dry environment.
Remove the spark plug, pour some oil in the
cylinder, turn the motor shaft a few times using the
starters to distribute the oil and install the spark
plug again.
Caution:
All maintenance work not
described in these instructions for use must be
performed at an authorised workshop.
Only use ORIGINAL spare parts from EDER
Maschinenbau GmbH.
