Page
1 of 2
©2006 Edelbrock Corporation
Brochure No. 63-0337
Catalog #5274
Rev. 5/06 - DA/mc
EDELBROCK LOWER TRAILING ARMS
for 1982-2002 Camaro / Firebird
Catalog #5274
INSTALLATION INSTRUCTIONS
®
Please study these instructions carefully before installing your new Trailing Arms. If you have any questions, please
contact our
Technical Hotline at: 1-800-416-8628
, 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time
or e-mail us at
. Please fill out and mail your warranty card.
Application:
Designed for 1982-2002 Camaro/Firebird vehicles. These trailing arms are designed to stabilize the rear
suspension, while improving suspension articulation.
Suggested Tools for Installation:
❑
Jack and proper load rated jackstands
❑
Blue Locktite
❑
Tire chocks
❑
Torque wrench
❑
Lug wrench
❑
Grease gun
❑
18mm socket and combination wrench
1.
Place vehicle on level surface and place tire
chocks in front of and behind front tires.
2.
Support rear of the vehicle on the jackstands
and remove the rear wheels
(See Figure. 1)
.
3.
Place a floorjack under the differential and lift up
slightly to remove tension from the trailing arm
bolts. Make sure not to lift the vehicle off the
jackstands
(See Figure 1).
NOTE: Keep floorjack under vehicle during
the complete removal and installation
procedure.
CAUTION: Do not remove both trailing arms
at the same time or the axle will rotate and
the trailing arm installation will be much
more difficult.
4.
Remove trailing arm bolts and trailing arms
(See Figure 2).
REMOVAL OF STOCK TRAILING ARMS
Fig. 1
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may
result in poor performance and engine or vehicle damage.
Fig. 2
