Rev. 3/03
RS/mc
©2003 Edelbrock Corporation
Brochure #63-0024
1. Let engine cool, raise hood and disconnect the negative
battery terminal.
2. Remove the throttle body air inlet hose and disconnect
the two water lines from underside of the factory
throttle body.
3. Disconnect vacuum hoses, electrical connectors,
throttle and cruise control cables from the factory
throttle body.
4
Remove the four mounting bolts from the throttle body
and remove the throttle body from the vehicle slowly -
ensuring that no other connectors are hindering
removal. Discard the four factory mounting bolts.
5. Remove the seven torx head screws from the water
crossover manifold on the bottom of the stock throttle
body. Clean all gasket surfaces and transfer the IAC
motor housing to the new throttle body using the
supplied gasket and screws - be sure the housing is
fully seated to the throttle body to avoid any leaks.
6. Re-install new throttle body to the manifold using the
supplied gaskets and bolts and torque to factory
specification (18 ft./lbs.)
Twin Throttle Body
for 1994-1997 Chevy 5.7L LT1 V8
Catalog #3809 (52mm) and #3810 (58mm)
INSTALLATION INSTRUCTIONS
Edelbrock Corporation • 2700 California Street • Torrance, CA 90503
Tech Line: 1-800-416-8628 • Office: (310) 781-2222
E-Mail: [email protected]
7. Reconnect all vacuum hoses, electrical connectors,
throttle and cruise control cables to the new throttle
body.
8. Re-install the negative battery terminal, refill the
coolant tank to allow for lost coolant and start vehicle.
Idle adjustments are made on set screw accessible
from the back side of throttle body on driver’s side of
vehicle.
9. If any idle adjustments are required, refer to the
factory specs. A scan tool may be needed to make
these adjustments.
Throttle Body Kit Contents
❑
1 - Throttle body assembly
❑
1 - Gasket; water crossover manifold
❑
1 - Gasket; throttle body
❑
4 - Bolts; throttle body mounting
❑
7 - Bolts; water crossover
❑
7 - Split lock washers
❑
1 - C.A.R.B. E.O. sticker
Please study these instructions carefully before installing your new throttle body
. If you have any questions or
problems, please call our
Technical Hotline at: 1-800-416-8628
, 7:00 am - 5:00 pm, Pacific Standard Time, Monday
through Friday or e-mail us at
Please fill out and mail your warranty card.
NOTE:
Larger than stock throttle bodies may require manifold bore-blending. If blending is done while manifold is installed,
exercise care in keeping aluminum chips and/or sanding dust from entering engine. Clean up debris and dust thoroughly
before installing throttle body.
SPECIAL NOTICE:
This Edelbrock part has received an Executive Order number (E.O.#) from the California Air Resources
Board (C.A.R.B.) making it legal for street use in all 50 states on 1992 through 1997 Chevy 5.7L LT1 V8s.. To assist you with
emission equipment certification, we have included a silver fan shroud decal to help testing personnel verify the this part is a
legal replacement on the vehicle for which it is cataloged. The adhesive-backed decal should be affixed next to the existing
emission and engine specifications decal. Do not cover any part of your original emission decal.
INSTALLATION
