TriTrax™ 200 Vertical Crawler
Document: UMDT017749.docm
Revision: A02
Created by: JS
Date: 13 Apr 2021
IPN: 3094329-A02
Source Location: C:\ePDM\ISLEng\Products\DT-VersaTrax100MkII\Manuals\UMDT017749.docm
Page 24 of 36
User Ma
nual
Post-Operations Check
A Post-Ops inspection should be carried out after every deployment using the following checklist:
1. Inspect the tether for damage as it is reeled in.
2. Visually inspect vehicle for entrained debris or mechanical damage.
3. Test each function to ensure proper operation.
4. Clean the system by hosing it down with water at regular line pressure. Do not pressure wash. The tracks
may be cleaned off by hosing them down while running. If the system has been used in saltwater, thor-
oughly rinse the vehicle with fresh water right away.
CAUTION:
Do not use a pressure washer to clean the camera. Very high-pres-
sure water can push past seals and flood the camera resulting in electrical dam-
age or personal injuries.
5. Take time to pack the system properly for transport away from the worksite.
6. Store the system in a dry environment.
Note:
Ensuring the
TriTrax™ 200 system is always stored in good working condition will minimize deploy-
ment time for future inspections.
