Versatrax 50™ In-Line
Document: UMBU014988.docm
Revision: A04
Created by: KJW
Date: 20 Nov 2019
IPN: 3080215-A04
Source Location: C:\ePDM\ISLEng\products\bu-vt50vehicles\manuals\UMBU014988.docm
Page 15 of 25
User Ma
nual
Spectrum 45 Camera Installation
The optional Spectrum 45™ camera is supplied with a 3-inch skid and mounting block.
1. Secure the mounting block to the camera using M3x12mm socket head cap screws.
2. Attach the flexible push link on the vehicle to the camera mounting block.
3. Install the skids using M3x10mm socket head cap screws. Note the orientation of the skid in the
figure below. A groove at the back of the skid captures it onto the camera mounting block, while
an open slot at the front allows for camera pan motion.
Drop Camera Configuration:
The Onyx camera and optional Spectrum 45 camera may be connected directly to the end of the tether to
form a drop camera system.
1. Remove the camera and tow cable from the vehicle or shipping box.
2. Connect the tether to camera
– make sure to align pins on connectors and blow out any moisture
or debris. Snug down the locking collar finger tight only
– do not use tools on the miniature
connector.
3.
Attach the tow cable to the cable grip on the tether using the quick link supplied. Ensure the load
is taken by the tow cable, and there is slack at the connector.
