Microtrac™
Document: UMDB007595.docm
Revision: B13
Created by: KB
Date: 17 Nov 2019
IPN: 3042830-B13
Source Location: C:\ePDM\ISLEng\products\db-microtracs4000\manuals\UMDB007595.docm
Page 11 of 26
User Ma
nual
Safety
In order to be able to use this product properly and safely, every user must first read these operating
instructions and observe the safety instructions contained therein. Take care of these operating
instructions and keep them in a place where they can be accessed by everyone.
CAUTION
: Failure to follow these safety instructions may result in injury or
equipment damage.
WARNING:
High Voltage
36-70 VDC.
If the equipment is powered from a source
other than an Eddyfi Technologies provided controller, the power supplied to the
product must have reinforced isolation from the mains with no reference to earth
ground.
CAUTION:
Disconnecting the track while the power is on can cause damage to the
camera. Disconnect the power source before servicing the product.
CAUTION:
High Temperature.
Under rated operating conditions this track can
become very hot, up to 80 °C (175 °F).
WARNING: Spark Hazard
- Under no circumstances should this equipment be
used in a potentially explosive atmosphere.
•
The
Microtrac 4000™ is an industrial product. All personnel operating or maintaining this
equipment must be competently trained.
•
There are no user serviceable parts inside. This product may be serviced only by qualified
technicians or trained personnel.
•
Eddyfi equipment is used in many varied environments from hot/dry to confined spaces to deep
underwater. Such diverse environment risks must be addressed by the operators who are trained
to work in such surroundings. As such, the operator is responsible to determine safe site setup
and appropriate procedures for operation and maintenance of the equipment.
•
Appropriate personal protective equipment (PPE) must be worn while operating and maintaining
the equipment.
•
Do not use the product or any component exposed to pressures higher than the rated working
pressure.
In addition, observe the following precautions when cleaning or servicing
the Microtrac 4000™
•
Do not operate the track with a damaged connector or cable. Inspect connectors and cables
regularly for damage.
•
Avoid creating a pinching hazard when designing a vehicle based on these tracks.
