KT600-AA
6
CHAPTER 2: HARDWARE INSTALLATION
2.1 C
ENTRAL
P
ROCESSING
U
NIT
I
NSTALLATION
(CPU)
Step 1:
Pull the lever sideways away from the socket and then raise the
lever up to a 90-degree angle.
Step 2:
Look for the white dot/cut edge. The white dot/cut edge should
point wards the lever pivot. The CPU will fit only in the correct
orientation.
Step 3:
Hold the CPU down firmly, and then close the lever to complete
the installation.
Step 4:
Put the CPU Fan on the CPU and buckle it. Connect the CPU FAN
power cable to the JCFAN1. This completes the installation.
2.2 FAN
H
EADERS
These fan headers support cooling-fans built in the computer. The fan
wiring and plug may be different according to the fan manufacturer.
Connect the fan cable to the connector while matching the black wire to
pin#1.
CPU FAN Header: JCFAN1
Pin Assignment
1 Ground
2 +12V
1
JCFAN1
3
FAN RPM rate sense
System Fan Header: JSFAN1
Pin Assignment
1 Ground
2 +12V
1
JSFAN1
3
FAN RPM rate sense
Note:
The JCFAN1 and JSFAN1 support 3-pin head connector. When
connecting with wires onto connectors, please note that the red wire is
the positive and should be connected to pin#2, and the black wire is
Ground and should be connected to GND.
