ECRM Mako 8 CTP, Руководство оператора, Страница: 21 / 56

AG114123 Rev. 2 15
ONLY 1 PIN BAR IN USE
OPTIONS: YES or NO
“YES” prevents the system from displaying a prompt to verify that
the correct pin bar is installed whenever you open an autoloader
cover. “NO” permits the system to display the prompt.
IGNORE LASER TEMPERATURE ERRORS
OPTIONS YES or NO
If the laser exceeds its target operating temperature an error will be
reported. It is recommended that this problem be fixed. However, if
critical jobs need to be completed, it is possible to operate the laser
at a higher temperature. This operation is enabled by ignoring the
laser temperature errors.
Note: Operating the laser at a higher temperature shortens the
life of the laser.
USE TRANSPORT AS AN OUTPUT TRAY
OPTIONS: YES or NO
“YES” disables the media transport conveyor and effectively
makes the transport function as an output tray. “NO” (the default
setting) enables the conveyor to operate and transport plates to the
processor.
USE THE PLATELINE INTERFACE
OPTIONS: YES or NO
“YES” enables the plateline interface to halt the platesetter when
another device in the plate line is not ready to perform its function.
“NO” causes the platesetter to ignore the plateline interface. This
feature should be set to “NO” if a plateline interface is not being
used.
OVERLAP OUTPUTTING AND IMAGING
OPTIONS
YES
or NO
If this option is set “YES,” an operator can begin imaging another
plate while the previous plate is still feeding into the processor.