Use the Hex Tool
Trays (2)
Dry Erase Board (1)
Chalk Board (1)
Easel Legs (2)
Parts List
A
B
C
BEFORE ASSEMBLING, MAKE
SURE YOU HAVE ALL THE PARTS
Hex Screws & Plastic Nuts (8/8)
E1
E2
D
Batch ID Sticker
located on backside
E
Clips (4)
F
1
Install the Dry Erase Board
Install the Chalk Board and Tray
2
Adjustable Art Easel
Model# ELR-008-B
Adult Assembly Required.
Two adults recommended.
- Contains small parts, sharp points and edges.
- Do not stand, sit, kneel, climb, lean or pull on
unit for support.
- Never leave children unattended.
- Do not place unit near high heat or moisture.
- Adult supervision recommended.
WARNING:
TOOLS INCLUDED
Hex Tool (1)
Open an
Easel Leg (D)
completely and secure the hinge into the locked position. Place onto a
protective surface with the locked hinge facing down.
Install the
Dry Erase Board (B)
onto
Easel Leg (D)
with two
Hex Screws &
Plastic Nuts (E1/E2)
as shown.
Open the other
Easel Leg (D)
completely and secure the hinge into the locked position.
Install the
Chalk Board (A)
onto both
Easel Legs (D)
with four
Hex Screws &
Plastic Nuts (E1/E2).
Align a
Tray (C)
behind the
Chalk Board (A)
before tightening the lower hex screws and plastic nuts.
Tip:
Install the upper Hex Screws & Plastic Nuts first.
Reminder:
Do not overtighten,
as the plastic threads can be
stripped.
Note:
The height of the
board/tray can be adjusted by
installing into upper/lower sets
of holes on the Easel Legs.
Carefully rotate onto the
Dry Erase Board (B)
on
a protective surface.
Reminder:
Do not overtighten,
as the plastic threads can be
stripped.
Carefully rotate upright.
See Next Page
Ca
refu
lly
R
o
tat
e ont
o B
Ca
ref
ully
Ro
tate Upright
Batch ID Sticker
San Diego, CA 92110 USA
www.ecr4kids.com
