- 7 -
Handle Bar Installation
1.
Loose the bolt on top of the stem, then Rotate the stem (Figure.2-1)
2.
Loosen the bolt on the side of the stem, then adjust the stem to a comfortable height (Figure.
2-2).
3.
Before installing the handle bar, please pay attention to the wires harness that connect to
it,they need to be placed as shown in the picture to prevent the wire harness from being
entangled (Figure. 2-3).
4
. Unscrew the four screws in front of the stem with 5mm hexagonal spanner, place the
handlebar on the stem, tighten the four screws slightly and position the handlebars to your
desired comfort level, then tighten four bolts in turn until fully tightened (Figure. 2-4)
5.
Once the handlebars are aligned and the top bolt is slightly secured, tighten the top bolt with a
5mm hexagonal spanner firmly (Figure. 2-5). After tightening the top bolt, tighten the two side bolts
with a 6mm hexagonal spanner firmly (Figure. 2-6). After all three bolts have securely fastened, make
sure there is no play in the headset.
WARNING:
Do not over-tighten the stem bolt. Over tightening the stem bolt can damage the steering system
and cause loss of control.
AVERTISSEMENT:
Ne serrez pas excessivement le boulon de tige. Un serrage excessif du boulon de potence peut
endommager le système de direction et entraîner une perte de contrôle.
