CAUTION!
- Disconnect power cord before servicing.
WARNING!
- UV Lamp operation. Do not operate unless the unit is completely
and correctly assembled. Failure to comply may result in serious eye damage.
RCI
™
Cell Replacement
If the unit no longer produces light
or the light has become dim (after
approx. 25,000 hrs of operation), the
RCI
™
Cell should be replaced.
Contact your EcoQuest Dealer for
more information on a replacement
RCI
™
Cell.
Remove the two
screws located at the
back of the unit.
Tilt the bottom of the
RCI
™
shield away
from the unit.
Lift the RCI
™
shield
up about 1/4” to
release it from the
upper tab.
Lay the RCI
™
shield
over and remove the
RCI
™
cell from the
retaining clips.
Remove the RCI
™
cell from the plug.
Replace with new
RCI
™
cell.
Reverse steps 1 - 4 to reassemble.
Note: The AC transformer may feel warm to the touch.
Over time some discoloration of the clear panel may occur.
Hg - LAMP CONTAINS MERCURY.
Manage in accordance with local laws.
See
www.lamprecycle.org
.
SPECIFICATIONS
• 12VDC
• 11 watts power consumption
• Advanced Oxidation: 0.01 ppm
• Size: 6” x 12” x 3”
(15cm x 30cm x 7cm)
• Weight: 2 pounds (.9kg)
• Coverage: up to 500 ft
2
(46m
2
)
• One Year limited warranty
- see warranty card for details
1
2
3
4
5
6
Operation
If your Fresh Air Spectrum UVX
™
has been equipped
with an international AC adapter, you will need to
select and install the proper plug (see below) .
Plug the adapter into a working receptacle and into
the back of the unit. Set the unit upright on a stable,
fl at surface.
Fresh Air Spectrum UVX
™
units with standard AC
adapters are controlled by a single on/off switch
located on the electrical cord. Units equipped with
international adapters do not have a switch.
ABOUT THE INTERNATIONAL PLUG ADAPTER:
When installing one of the interchangeable plugs, be sure to snap
and lock the plug into the adapter. When removing a plug, press
the raised tab to release, then slide the plug out the top.
PRESS HERE
