Ecom DK50, Инструкция по установке, эксплуатации и обслуживанию

Страница: 15 / 60

DK50
04/2015 - 13 - NP-DK50 simple s DE-2_04-2015
16.3. Inspect the appliance
Test for leakage:

Consumption of compressed air is stopped.

Pressurize the air tank by releasing some air via a connected device.

With the compressor off, wait at least 10 minutes before checking the pressure level.

If the pressure has dropped, use soapy water to find the leaky joint. Start with the joints outside the case,
then test the ones inside the case after removing the covers.

Tighten or re-seal joints as necessary.
Inspect the appliance:

Check the status of compressor aggregate – uniformity of operation, noise level, check the performance of
the compressor - measure time of pressurizing of air chamber from 0 to 6bar (35 sec).

Check the condition of the hangers above the pump.

Checking the fan functioning.

Examine the pump for:
- impurities in the crankcase, free movement of the crank shaft, if necessary, replace any faulty parts
16.4. Stabilizing the compressor before shipping
(Fig.8)
Before shipping, the compressor must be stabilized to
prevent movement. Prior to fixing it is necessary to
disassemble housing using 4x screw M5 at side walls of
the product. The air pump must be fixed to the base using
four original screws M6 (see picture) and plastic cover
assemble.
16.5. Replacement of filters of air pump
Caution – hot surface! About disassembly the internal back cover can be hot the internal
surface.
(Fig.9)

Disassembly the internal cover. These filter inserts are in the top
cover of crank case.


Using screwdriver, remove the flexible guard.

Remove the used and contaminated filters (A), (B).

Insert a new set of input filter (B).

Place prefilter (A) into the flexible guard (by plain side into the crank
case) and then to the opening..
17. STORAGE
If the compressor will not be used for a prolonged time period, drain any condensate from the air tank. Then
turn on the compressor for 10 minutes, keeping the drain valve open (8) (Fig.1). Switch off the compressor
by switch (Fig.4), close the drain valve and disconnect the appliance from the mains.
Fig.8
Fig.9