© 2016 Ecolink Intelligent Technology Inc.
PN FF-ZWAVE5-ECO
TM
Audio Detector Installation Instructions
Product Overview
Z-Wave+
™ enabled device which provides fire and CO (carbon monoxide)
status
Transmits Fire and CO alarm status
Reports tamper condition when cover is open
Product Specifications
For indoor use only
Detection Distance: 6 inches max
Operating frequency: 908.42 MHz
Operating temperature: 0°
– 49°C, 32° – 120°F (ambient temperature)
Operating humidity 5-95% non-condensing
Battery type required: 3V Lithium CR123A
Battery life approximately 5 years
Network Inclusion
The sensor must be added to a Z-Wave network prior to use. To include the sensor in a network both the
sensor and the network controller must be in inclusion mode at the same time.
Refer to the instructions
provided by the manufacturer of your specific controller for details on initiating the controller’s inclusion mode.
1)
Verify that the Z-wave Plus controller you are using is compatible with the FireFighter
tm
.
2)
Either mount or move the FireFighter
tm
sensor as close as possible to the location the sensor will
remain. See installation section below.
3)
Put your Z-wave Plus Controller into add (inclusion) mode.
4)
Open the FireFighter
tm
case and press the learn button on the device for one second. If the LED
starts blinking continually, the sensor has not been added. Repeat steps 3 and 4.
Network Exclusion
1)
Any sensor can be removed from any Z-Wave Plus controller. Follow the directions to put your Z-
Wave Plus Controller into exclusion mode.
2)
Open the FireFighter
tm
case and press the learn button on the device for one second. If
successfully removed from the Z-Wave Plus network, the devices Green LED should blink slowly
continuously.
