Ecolab EcoPro, Руководство по эксплуатации

Страница: 104 / 550

2 Safety
2.1 General Safety
DANGER!
If you assume that safe operation is no longer possible the pump must be put
out of service immediately and be secured against unauthorized use.
This is the case if:
– is visibly damaged
– appears no longer functional
– prolonged storage under unfavorable circumstances has occurred
(carry out function check).
The following notes should be observed:
– Before any work on the electrical section, disconnect power and secure
against being switched on again .
– The safety provisions for handling chemicals must always be observed and,
if applicable, suitable protective clothing must be worn
– Notes in the product data sheet of the used dosing medium has allways to
be observed.
– The installation may only used with the specified supply and control voltage
in the technical data.
2.2 Proper use
WARNING!
Proper use particularly includes the following points:
– Only validated chemical liquids may be metered.
– Depending on the material used, the metering system is designed for clean,
alkaline products.
– The temperature application range, the permissible ambient temperature
and the maximum media temperature are only permissible as indicated in
the "Technical Data".
– The metering capacity is between 5 and 120 l/h depending on viscosity and
back-pressure.
– The back-pressure must not exceed 1 MPa (10 bar), to DIN EN 809.
– The operating voltage may only be established as indicated in the
"Technical Data".
– The ambient temperature must be b5 and +45 °C.
– The pump has been developed, designed and built for industrial and
commercial use. The unit is not intended for private use!
Any use which extends beyond or differs from the appropriate use is
considered improper use.
Intended use also includes compliance with all control and operating instructions
stipulated by the manufacturer, as well as with all maintenance and servicing conditions.
Safety
12 417102264 Rev. 5-01.2019