Ecolab EcoAdd, Руководство по эксплуатации

Страница: 139 / 204

9.4 Setting or changing the pump capacity in L
The following screens show example displays for a pump with capacity of
11 l/h. Specifications and information shown will differ for other pump sizes.
Fig. 93: Changing the pump capacity in L during ongoing operation
Set or change the pump capacity in L:
1.
On the operation screen, press the displayed ‘capacity in L’ :
To access the settings, press and hold the displayed ‘capacity in L’ for
around 3 seconds.
2. If a password prompt is not displayed, you can skip this step.
If the [access code] is enabled , please note the following:
Ä
Chapter 7.6 ‘Main menu’ on page 66.
NOTICE!
We strongly advise that you enable the security settings.
Ä
Chapter 7.9.4 ‘Access code’ on page 88
ð
The screen switches to the screen for setting the ‘capacity in L’ .
3. Use the scrollbar to set the ‘capacity in L’ before the decimal point.
4. Select the field for entering the value after the decimal point.
ð
The colour changes to dark blue, which indicates that the field is ready for input.
5. Use the scrollbar to set the ‘capacity in L’ after the decimal point.
6.
Press the button.
ð The pump saves the settings and switches back to the operation screen. The
operation screen shows the new ‘capacity in L’ .
Operation
139 Rev. 2-05.2018