Ecolab 417102214, Руководство пользователя

Страница: 92 / 182

417102214_EDPL_V60.docx 92 Rev. 1.12.11
10.4.4 Configuration / Unit
If 'litre' is selected for the ‘Internal’ operation mode (see chapter 10.3.2.2 “ Display value in
the operating level / Setting ”), this can be used to change the display from litres / h to gallons
/ h or gallons / day ( 1 gallon = 3.785 litres) .
10.4.4.1 Selection
Fig. 10.23
Default setting: Litres
10.4.5 Configuration / Max. output
The maximum metering capacity of the pump can be limited here.
The value is entered as a percentage and can be set at intervals of 10 between 100 % and
30 %. A setting of 80 %, for example, means that the maximum value for the metering
frequency (metering quantity setting of 100 % in 'Internal' operating mode or a current input
of 20 mA in 'Current' operating mode) only reaches 80 % of the maximum possible metering
frequency.
Example: Pump type 02200 (220 l/h),
calibrated with water at 20 °C,
short suction and pressure lines
Max. power setting = 100 % Max. power setting = 80 %
metering mode: standard [s] medium [m] low [l] standard [s] medium [m] low [l]
Max. possible metering frequency [1/min]: 120 100 80 96 80 64
Max. possible metering quantity in l/h: 220 183 147 176 149 122

IMPORTANT
After every adjustment under the 'Metering capacity' menu option, the pump must be re-
calibrated! Therefore, the icon "c!" appears in the operating level display.
Once automatic calibration has been correctly performed, the icon "

" then appears!
10.4.5.1 Selection
Fig. 10.24
Setting range: 100% – 30%
(in 10 % intervals)