ECOFOREST ecoSMART Supervisor, Руководство для пользователя, инсталлятора и технической службы

Страница: 24 / 40

ecoSMART Supervisor user, installer and technical service manual
24
EN
Icono Significado
Heat pump ON
Heat pump compressor OFF by EVU signal
Heat pump OFF by Supervisor
Heat pump OFF by BUS
Heat pump Off by CONTROL PANEL
Heat pump Off by ALARM
Heat pump LOCKED by alarm
Table 5.2. Heat pump states in pLAN.
NOTE

The EVU signal is used in some countries by the electricity company to control electrical
consumption. The EVU signal prevents energy production by the compressor and the auxiliary
equipment. Circulator pumps, valves and other components can be activated to consume energy
from the storage systems.
ECOGEO GROUP ON/OFF. Allows modified the percentages minimum and maximum of rpm between heat pumps work with
best COP, also changed the time ot of this range to turn ON / OFF the next heat pump.
MENU 1.2. SCHEDULE
MENU 1.2.1. Date/time
DATE/TIME. Here it is possible to set the date and time of the supervisor control program.
CLOCK. Here it is possible to enable/disable the automatic time change between seasons. Allows changes to be made to
the time zone to be applied and the dates/times when time changes occur.
MENU 1.2.1. Holidays
Allows three holiday periods to be defined during which the supervisor RESPONDS / DOES NOT RESPOND to the services
requested. The settings on this screen override the settings of the time schedules for each of the services.
MENU 1.3. HEATING
HEATING. Allows the heating cut-off temperature to be adjusted, i.e., the maximum outside environment temperature over
which the system does not respond to heating demands. Also shows the heating connection type (DIRECT / BUFFER).
HEATING SETPOINT. Shows the heat pumps connected to supervisor with heating enabled, also displayed heating setpoint of
each heat pump. The temperatures are the setpoint and the temperature gradient set point in case of installing exchangers in
each heat pump.
MENU 1.4. COOLING
COOLING. Allows the cooling cut-off temperature to be adjusted, i.e., the maximum outside environment temperature below
which the system does not respond to cooling demands. In installations with free and active cooling must configure two
temperatures, the free cooling cut-off temperature, it is the same that cooling cut-off temperature that we have described,
and the active cooling cut-off temperature, over which the system only make active cooling. Also shows the cooling
connection type (DIRECT / BUFFER).